There are 3 ports on the chamber that I made slits in the plastic to get around and taped them up once around them. Do not tape to the insulation. Tape only to the vapor barrier plastic. It doesn't take long, just be careful. After the plastic is in place and secure around the chamber I sealed the plastic to the back of the front and back panels using the packing tape. All the way around the front and back of the chamber to completely seal the chamber from outside air and humidity.
Raw eggs freeze dry very well. I like to crack them into a bowl, whisk them, and then freeze them solid before freeze drying. To reconstitute, use 2 tablespoons of egg powder and 2 tablespoons water to equal one egg. Use them in an recipe or scramble them up. They taste delicious.
I found out the hard way about the anti-drainback seal when I first tried the filter and got... nothing. I did do some research afterward and learned, as you point out, that there are some filters than don't use the seal but by then I was committed. Fortunately, it wasn't all that hard to remove it, but definitely better not to have to.
I take trips to larger stores to stock up on gluten-free and lactose free staples. Then I can use those to make meals or freeze dry the individual components.
I removed the side covers and found the water dripping from the chamber insulation. I called up HarvestRight to ask for ideas on how to avoid this in the future.
Odds are the problem is the vacuum hose or Buy Now its end connections, the drain valve, or the door gasket. Based upon my experience I'd double check the fittings while installed on the FDer.
We also like to freeze dry gluten-free sweet breads and muffins. Slice bread or muffins and freeze dry it. Then to reconstitute, simply wrap it in a wet paper towel and leave it in the fridge overnight or put it in the microwave for up to 30 seconds.
3) Inside the front panel I installed a plastic shield over the display card and a water deflector just below the hole to route the exterior condensation to an 11x17 pan beneath the FDer.
Drying things out played a roll as well as the added insulation. We had 3.5 weeks of constant rain here in central NC with humidity over 95% and temps near 95F in the beginning and tapering down to 80F by the end of the rain. The condensation on the front panel around the seal had water running down the front of the Freeze Dryer constantly during the entire cycle, not just the freeze cycle. I initially went into the FDer to simply stop the humdity from reaching the outer chamber shell and freezing.
We had a sponsored post come over on my other sites that asked the question, “Should you buy a freeze dryer?
A description of the product, including details such as build quality, materials used and reasons to purchase.
Hey there, fellow self-reliant folks! If you're all about preparedness and want to take your food preservation game to the next level, you've probably considered getting yourself a freeze dryer. But let's be honest – freeze dryers aren't exactly known for being wallet-friendly.
Depending on how you want to use freeze dried food, it doesn’t have to be reconstituted. There are some freeze dried foods I like to powder in my blender or food processor and then add to other foods. These powders can be used in smoothies, soups, and baked goods.
Slight delay at customs but my head was spinning at how fast this was resolved for something that was out of there control! Bravo!